Logo Bendywood®

HANDRAIL
in American walnut, machined from Bendywood® raw section 80x50x6000 mm to desired section shape, cut in 2 halves (vertically) with Bendywood® feather joint, than bent and glued directly on the metal plate of the banister.

Halving the profile allows bends up to R70 cm, as 2 parts 35x40 mm are bent.
The full profile 70x40 mm can only be bent up to R140 cm

Corrimano OM 3D 6010 EN
The feather joint connection prevents the 2 halves from slipping during 3 D bending when bent upwards against torsion.
It is also recommended to glue with help of negative pressing blocks in order  to achieve a clean – not visible – glue joint when gluing the 2 halves together.

If the radius to be bent is larger than R140 cm, the 70x40 mm profile can be bent whole, i.e. not cut into 2 parts.
For the bending limit see the following link:
Handrail bending (bendywood.com)

Handrail profile with groove to be mounted on an iron plate must be pre-bent so as not to damage the groove-walls during assembly on the curved iron plate.
Please see:
Bending moulds for Bendywood® handrails, and Spring-back after being taken from the moulds (bendywood.com)

VOLUTE
had been made from normal American walnut on a 5-axis CNC router

Bendywood® is easy bending in top quality!